WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
2
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION
STEP 1:
1.
Make sure your main power is off.
2.
Prior to installing the fixture, secure the anchor bolts
And alignment plate into the cement. Insure the leads,
electrical wires are passing up through the center hole
of the alignment plate.
(Note: Bollard Orientation is critical.
See Bollard Orientation section for detail.)
For shallow base bollards, insure that the anchor bolts
length on top of the cement surface do not exceed
1-1/8” (29mm).
3.
After the cement has cured, remove the alignment
Plate and install the Fixture Baseplate until it’s secure. Again,
make sure to feed the leads, electrical wires up through the
center hole of the baseplate.
Use leveler to ensure that the baseplate is leveled.
4.
Connect the supply lines from the supply conduit to the
fixture input wires per the local electrical code.
(See Wiring Diagram Below)
Tie the wires so that they do not lie on or have
Contact with the ground.
5.
Set the Bollard Fixture onto the Fixture Baseplate
6.
Secure the fixture by tighten the Fixture Mounting
Screws with Hex Key. Be sure not to crimp any wires between
the Fixture Baseplate and the Fixture Housing Tube.
7.
Turn the main power supply back on and make sure the
fixtures light up.
8.
You have now completed the installation of your fixture.
Alignment Plate
Anchor Bolt
Fixture Housing
Bollard Fixture
Wiring Diagram
Fig.1
Fixture Mounting Screw
Fixture
Fixture
Fixture
Wires
Black or
Smooth
Wires
White or
Ribbed
Wires
Bare
Copper
(Ground)
House
Wires
Black
(Hot)
Fixture Baseplate
Anchor Bolt
Cement
Outdoor Rated Wire Nut
Hex Nut
Hex Nut
Spring Washer
Flat Washer
Hex Nut
Cement
29mm
1
8
”
INSTALLATION INSTRUCTION
Bollard Light 120V/277V
6612 / 6613 / 6622 / 6623 / 6632 / 6633 / 6642 / 6643
House
Wires
White
(Neutral)
House
Wires
Bare
Copper
(Ground)
