WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
2
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
Bollard Light 12V
6611/6621/6631/6641/6651
INSTALLATION
1.
Make sure your main power is off.
2.
Excavate a trench for the Mounting Stake.
The Mounting Stake requires approximately a one (1) square
foot hole to facilitate installation.
The excavated should be approximately 14” deep, depending
on your local code. This will allow the hex-head set screw on
the Mounting Stake to remain above ground when the
installation is completed.
3.
Secure Fixture Mounting Plate onto the Stake Metal Cap by
using the Stake Mounting Screws.
4.
Secure the Stake Metal Cap assembly onto the
Mounting Stake by tighten the Cap Mounting Screw
(Note: Make sure the Fixture Mounting Plate is
Oriented at desired position.)
5.
Secure the Bollard Fixture on top of the Fixture
Mounting Plate using the Fixture Mounting Screws.
6.
After proper wirings are done by using the outdoor rated wire
nuts, back fill the hole and make sure the fixture is leveled and
stable.
7.
Turn the main power supply back on and make sure the
fixtures light up.
Bollard Fixture
Fixture Mounting Screw
Stake Mounting Screw
Cap Mounting Screw
Mounting Stake
Fixture Mounting Plate
Stake Metal Cap
