l
Hanger Bal
n
Pi
d
Downro
Set Screw
1. Remove the hanger ball portion from the
downrod/ hanger ball assembly by loosening
the set screw in the hanger ball until the ball falls
freely down the downrod. Remove the pin from
the downrod, then remove the hanger ball. Retain
the pin and hanger ball for reinstallation.
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation.
3. Loosen the two set screws in the downrod
support of the motor assembly. Route the blue/
white, red, gray, yellow wires and safety cable
through the downrod.
4. Thread downrod into the collar on top of the
motor. Install the clevis pin by aligning the holes in
the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two
set screws with nuts in the downrod support.
5. Slip the coupling cover, canopy screw cover
Black/White, Blue,
Red, Gray, Yellow
wires and safety cable
Downrod
Set Screws (2)
d
Downro
Hairpin Clip
)
Locking Nuts (2
Set Screws and
n
Clevis Pi
Blue/White, Bl
F-081L/ F-083L
12
07
HANGING THE FAN
4
6
5
7
n
Clevis Pi
Hairpin Clip
Cross Pin
Blue/white, red,
gray, yellow wires
and safety cable
