3
3. Measure the desired length of tape light and round it off to the nearest 4-inch interval. Determine necessary
quantities of other accessories and power supply need for each run. Do not exceed maximum run
recommended for each tape series
4. If necessary, cut tape light to desired length at line indicated with scissors icon. The tape allows for a cut
every 4-inch interval. The cut line is shown on both sides of connector.
5. Mount Tape Light: Clean surface before mounting. Peel off 3M adhesive backing cover off as strip is installed,
pressing firmly to mounting surface in increments.
6.
Joining between tapes:
•
Joining tape together (If necessary), the following accessories can be used to join between tapes section
depending on your application:
Tape to Tape Connector (T24-MM-WT)
Another way to join between tape is to use soldering method. Before soldering, making sure to scrap off
the polyurethane coating on the surface of the copper pad using a sharp cutter or knife blade.
Peel back during
installation
Adhesive back cover
