dweLED retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
Jan 2019
2
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
S
178 – LED Wall Sconce
WS-17825/WS-17837
PREPARATION
1.
2.
CONNECTING THE WIRES
(Fig. 2)
3.
4.
Connect the driver input wires with junction box wires as shown in Fig.2, making sure that all wire connectors (A) are secured. If your outlet
the mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE
(Fig. 1)
5.
Secure the mounting plate to the junction box using junction box screws (B). The side of the mounting back plate marked “GND” must face
out.
6.
7.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Fig. 1
D
WS-17825&WS-17837 Back plate
C
D
A
B
C
Mounting Screw
Fixture
B
Junction Box Screw
Mounting Plate
Driver 2 3/4"L 1 1/4"W 1 3/16"H
A
Wire Connector
Junction Box
Female/Male end connector
7MBC151106
Mounting Screw
Rubber Gasket
B
C
Wire Connector
A
Junction Box Screw
Backplate
Junction Box
Junction Box
Wires
134" 1
3
8"
WS-W64905: 3 7/8" WS-W64906: 4 1/8" WS-W64908: 5 7/8"
WS-W64905: 4 1/4"
WS-W64906: 5 1/4"
WS-W64908: 6 1/8"
Back Plate Dimensions
3.
Remove the mounting screw (B) and the rubber gasket (C) from the mounting back plate.
ed. If your outlet box
wire directly to
the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
4. Secure the mounting plate to the junction box using junction box screws.
NOTE:
The side of the mounting back plate marked “GND” must face out.
MOUNTING THE FIXTURE (Fig. 1)
ssary for installation.
PREPARATION
CONNECTING THE WIRES (Fig. 2)
7.
To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline
.3.
COMPLETING THE INSTALLATION (Fig. 1)
Junction Box
Caulking
Fig. 3 Sealing
649 Outdoor Wall Sconce
WS-W64905/ WS-W64906/ WS-W64908
