![background image](http://html1.mh-extra.com/html/wac-lighting/dweled-139-series/dweled-139-series_installation-instructions_3116205002.webp)
WAC Lighting
www.waclighting.com
Phone (800) 526.2588 • Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone (516) 515.5000 • Fax (516) 515.5050
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone (800) 526.2588 • Fax (800) 526.2585
dweLED retains the right to modify the design of out products at any time as part of the company's continuous improvement program.
Jan 2019
2
INSTALLATION INSTRUCTION
S
159&139 – LED Outdoor
WS-W15912/ WS-W15918/WS-W15924/ WS-W13918
Fig.1
PREPARATION
1.
Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2.
Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary
for
installation.
MOUNTING THE FIXTURE
(Fig. 1)
3.
Remove the mounting screw (B) and gasket (C) from the mounting back plate.
4.
Secure the mounting back plate to the junction box using the screws provided with the junction box.
NOTE:
The side of the mounting back plate marked "GND" must face out.
CONNECTING THE WIRES
(Fig. 2)
5.
Connect the fixture's wires to junction box wires as shown
(Fig. 2)
. Make sure that all wire connectors (A) are secure
.
If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect
the
fixture’s ground wire directly to the back plate using the green screw provided. After wires are connected, tuck
them
carefully inside the junction box.
COMPLETING THE INSTALLATION
(Fig. 1)
6.
Secure the fixture to the mounting back plate using the mounting screw (B) and gasket (C).
7.
To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor
silicone sealant) to outline the outside of fixture back plate where it meets the wall. Leave a space at the bottom to
allow moisture to escape
(Fig.3)
.
Fig.
2
Wiring