WAC Lighting 5031-CCBBR, Installation Instruction

Page: 3 / 22

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JAnuAry, 2016 3
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
In-Ground Color Changing
5031-CCBBR
SOFTSCAPE INSTALLATION
CUSTOMIZE SETTING
1.
Turn the main power off.
2. Dig a hole at the point of application. Make sure the hole
measures at least 4-5/8 inches in diameter and 10 inches in
depth. (
Fig.6
)
3. Place a layer of pea gravel (3 inches) at the base of the hole
to help with drainage.
4.
Connect the fixture wires to landscape wires coming from
the transformer using the outdoor rated direct burial wire
nuts provided.
5. Place the fixture in the hole and repack the soil to hold it in
place. Make sure the trim is flush with the ground.
This fixture is equipped with three customizable settings:
Dimming Adjustment, Beam Angle Adjustment, and Beam
Aiming Adjustment. It can be pre-set into desired settings by
taking the light engine assembly out from the fixture housing.
( Fig. 7 )
1.
Unscrew Face Plate Screws with hex L-key.
2.
Take out the Face Plate, Gasket, Front Glass and
accessory lens (if any).
3.
Pull the Light Engine out of the Fixture housing.
Note:
Light Engine can be taken out remotely by disconnecting
the Quick Connector. Users can later reconnect it back into the
housing after all desired settings are been made.
Fig.6
Fig.7
Soil
Outdoor Rated
Wire Nut
From
Transformer
Face Plate Screw
Face Plate
Gasket & Front Glass
Accessory
Light Engine
Quick Connector
Fixture Housing
Beam Angle
Adjustment
To Next
Fixture
4 5/8”
10”
3”
Pea Gravel