13
During operation, do not overload the machine
-
use only essential for the proper functioning of the
pressure.
When a
power
tool is
failure
the machine must reach a state of security
(Power off / plug off power
cable). When you turn on the power supply the machine can not automatically continue the interrupted
work.
All covers, screens responsible for safety must be maintained at full technical efficiency. In the event
of damage, immediately repair or replace them with new ones.
Each time, before you start
the tool check
the technical condition. If you find damage, cracks,
scratches or deformations do not use it
-
replace tool with
defects.
Do not use
the machine with blunted bits.
Do not use diamond bits that do not meet the technical parameters specified in the manual.
Before first starting up, check that the supply voltage corresponds to the nameplate value.
Do not use tools in accordance with their intended use.
Do not operate the machine near containers of flammable liquids or gases.
Do not lift the machine by pulling the power
cord and do not pull on the cord when its unplugged.
It is forbidden
to
left
the machines in the rain, or use it by
moisture. Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting edges
are less frequently to locked
and are easier
to control.
