8
Installation Procedures
Fig. 4
4014089b
“B” MOUNTING HOLES
4. Assemble the radar to the mounting bracket using the 3 M6 fl anged nuts and tighten to
61-75 in-lbs (6.9-8.4 N m).
5. Remove the bumper according to the vehicle manufacturer’s recommended instructions.
6. Place the radar bracket assembly in mounting position on the cross member just below the hood
mount pivot. Install the two ½-13 fl anged bolts provided in the kit (Figure 5) and tighten to
80-110 ft-lb (108-150 Nm).
Fig. 5
4014093a
7. If necessary, modify the air dam baffl e to clear the radar bracket. If a center fl ap is present, cut it back
to the cross member so it is fl ush (Figure 6). After modifi cation, ensure the radar bracket does not
bind on any part of air dam when installed.
Fig. 6
4014094a
8. Install the fascia over the radar.
Summary of Contents for OnGuard
Page 2: ......