Position the PC board assembly onto the acrylic chassis with the pin headers toward the
panel and the jacks and power pot to the rear. Secure the board to the chassis with 4 of
the 3mm nylon screws. Connect the volume control harness connector to the 4-pin
header on the right side of the board. Note that the connector will not mate if reversed.
Connect the tuning control harness to the 5-pin header on the left side of the board.
Neatly dress the harness wires. Install the clear plastic protector on the upper standoffs
with the 4 remaining m3 screws. Check that the engraving is oriented properly. This
completes construction.
Summary of Contents for Acrylic NO-SOLDER 40M Xceiver
Page 5: ......
