W2IHY Master CD9, Assembly Instructions Manual

Page: 8 / 13

( ) Install J6 (Pwr) - 3 pin DIN connector on the back of the case.
(This will require 2 screws, 2 lock washers and 2 nuts)
( ) Install J5 (MIC IN) - RCA Plug on the back of the case
( ) Install J4 (PTT) - RCA Plug on the back of the case
( ) Install J2 (MIC IN) - 8 Pin Male Mic Connector on back of case
( ) Install J3 (MIC OUT) - 5 Pin DIN connector on the back of the
case. (This will require 2 screws, 2 lock washers and 2 nuts)
( ) Install slide potentiometers R15,R16, R17 (100K) and R18 on front
panel. Orient potentiometers as shown in Figure 1.
( ) Install plastic LED holders on front panel.
( ) Install switch S1 on front panel - Power switch.
( ) Install switch S2 on front panel - Noise gate switch.
( ) Install switch S3 on front panel - Equalizer on off.
( ) Install Orange (or yellow)LED LED3 in holder (as shown in figure 1 .)
( ) Install Green LED LED1 in holder (as shown in figure 1 .)
( ) Install Red LED LED2 in holder (as shown in figure 1.)
( ) Pre-wire Rotary switch S4 as shown below and install on rear
of case. The wires going to J2, J3 and J4 should be cut to 3.5
inches. They can be trimmed when the switch is installed in
the case and wired. Pre-wiring the switch, with insulated wire,
makes wiring it significantly easier. (2 center posts on S4 wired later)
( ) Install the pre-wired switch S4 - Mic Select. Pay attention to
the alignment of the switch (per the figure 1). Install the round
knob so the center position of the switch has the knob align
to K (Kenwood)
ALL PARTS ARE NOW MOUNTED ON THE CASE
The following 3 pages are instructions for installing the
Equalizer/Noise gate hardware in the case. Refer to
figure 1 to determine the location and orientation of the parts.
The parts may be found in bag #2 envelopes # 4 & 5.
Nut
Washer
Chassis
Nut
S1,S2,S3 Mounting
S4
-7-