GETTING STARTED TUTORIAL
-17-
Audio Input Gain (5)
Monitor Level
Audio Input Gain
so that 2 or 3 Green Bar Graph LED’s
light up. This may require adjusting both the Mic Gain control
on the 8 Band EQ and the Audio Gain control on the EQplus.
Connect a set of stereo headsets into the 1/4 inch “
”
Connector located in the back of the EQplus. Talk into the mic
to hear audio coming from the EQplus. Adjust the headset
volume by turning the front panel
control (17)
If you are using an external audio device, such as a W2IHY
8 Band EQ, use the same equalizer settings you were using prior
to using the EQplus.
Turn the
(7) on. Turning the
potentiometer (9) clockwise up will increase the amount of high
frequencies present in the
(23) The detent midway
through the rotation is 0dB gain point. Turning the
potentiometer (8) clockwise will increase the amount of low
frequencies present in the
(23) The detent midway
through the rotation is the 0dB gain point. Experimentation will
be required to determine the optimal settings for the Equalizer.
- With the Compressor/ Downward Expander off, the audio
level, as seen on the LED Bar Graph, should be adjusted so
that 2 or 3 green LED’s are on. This level may be adjusted
using the
control (5).
- Turn the
(10). Turn the
control (12) fully counter
clockwise. This will effectively turn the Downward Expander off.
..
Using The EQplus headphone (PHONES) Monitor
Adjusting an External Equalizer connected to the EQplus
Adjusting the EQPlus Dual Band EQ
USING THE COMPRESSOR/ DOWNWARD EXPANDER
Phones
Equalizer Switch
Treble
Audio Out
Bass
Audio Out
Compressor / Downward Expander on
DE (Downward Expander )
