8 Port Fast Ethernet PoE Switch
Make sure the equipment is installed according to the manufactures installation guide.
Confirm RJ45 cable order meets EIA/TIA 568A or 568B standard.
Every PoE port can provide PoE equipment maximum power less than 30W, please
do not connect the PoE equipment with power over 30W.
Replace the equipment with a proper functioning 8 Port PoE Ethernet Switch to
check if the equipment is damaged.
Please contact W Box Tech Support 833-574-9124 (Option 2),
email at info @wboxtech.com or the installing company
Total PoE power between all 4 PoE ports is limited to 62W
Instruments to be used: wire crimper, network tester and wire sequence of RJ45 plug
should conform with EIA/TIA568A or 568B.
1 Please remove 2 cm of the insulating layer and bare 8 pairs UTP cable
2 Separate the 8 pairs UTP cable and straighten
3 Line up the 8 pieces of cables per EIA TIA 568A or 568B
4 Cut off the cables to leave 1.5cm bare wire
5 Plug 8 cables into RJ45 plug make sure each cable is in each pin
6 Use the wire crimper to crimp
7 Repeat above steps to make additional ends
8 Use network tester to test the cable
1 White/Green
2 Green
3 White/Orange
4 Blue
5 White/Blue
6 Orange
7 White/Brown
8 Brown
1 White/
2
3 White/Green
4 Blue
5 White/Blue
6
7 White/Brown
8 Brown
Orange
Orange
Green
EIA/TIA 568A
EIA/TIA 568B
Notice
When choose RJ45 make sure if one end is EIA/TIA568A then other end should also be EIA/TIA568A,
When choose RJ45 make sure if one end is EIA/TIA568B. then other end should also be EIA/TIA568B,
Trouble Shooting
Plug Producing Method
15
Commutateur Fast Ether net PoE à 8 ports
