vYSoo MR600, User Manual, Page: 30 / 75

27
6
Chapter 6 Configuration
Authentication: You ma y s elect Open Syste m , Shared Key or Auto . The
default is A uto. If you select Open System, your network will
not be secure. Select Shared Key to create a secure network
authentication betwee n your WLAN host a nd the Mo bile
Router. To enable this setting, provide a ten-character
(alpha-numeric) key in the ASCII Key field.
Fragmentation
threshold:
The fragment ation thre shold, which is specified in byte s,
determines whether p ackets will be fragm ented. Packet s
exceeding the 2346 byte setting will be fragmented before
transmission. 2346 is the default setting
RTS Threshold:
This value should remain at it s d efault sett ing of 2346 . If
inconsistent data flow is a problem, only a minor modificatio n
should be made.
Beacon Interval:
Beacons are packets sent by an Access Point to synchronize
a wireless n etwork. Specify a value. 100 is the default setting
and is recommended.
DTIM: (Delivery Traffic Indication Message) 3 is the default setting. A
DTIM is a countdown informing clients of the n ext window for
listening to broadcast and multicast messages.
RF Output Power: Set the transmit power of the antennas.
Preamble Type:
Select Short or Long Preamble. The Preamble defines the
length of the CRC block (Cyclic Redundancy Check is a
common technique for d etecting data transmission errors) f or
communication between the wireless router an d the roaming
wireless net work adapters. Auto is the default setting. Note:
High network traf fic are as should u se the shor ter preamble
type.
IAPP: IAPP (Inter-Access Point Protocol) is a re commendation that
describes an optional st andard that provides AP
communications among multi-v endor systems. The default is
Enable .
802.11g Protection: Enable this mode if yo ur network is made up both 802.11g
and 802.11b devices. I t can impro ve the performance when
your network is mix with 802.11b and 802.11g wireless clients.
Mobile Router
www.vysoo.com