VXI BlueParrott B100, User Manual

Page: 11 / 26

the call (see Switch From Handset To Headset While On A Call on page 15). Or
if desired, you may initiate three-way conferencing via the headset, as
follows:
1. Be sure the headset is in Standby Mode.
2. Press the Multifunction button for 1 second, and release. After a brief pause,
you will hear a dial tone.
3. Remove the handset from the cradle (corded phone), or push the Talk/On
button (cordless phone) and dial one of your parties. When the phone begins
to ring, hang up (or turn off) the handset.
4. When the second party answers, tell them to stay on the line.
5. Initiate the flash/hook switch function by pressing the multifunction button
twice rapidly. Do not hold the button down too long or you will disconnect
the call. Afterwards, you will hear a beep followed by a dial tone.
6. Remove the handset from the cradle (corded phone) or push the Talk/On
button (cordless phone) and dial the third party. When the phone begins to
ring, hang up (or turn off) the handset.
7. When the third party answers, press the multifunction button twice rapidly to
connect all 3 parties. Do not hold the button down too long or you will
disconnect the call.
8. To disconnect all parties, press the Multifunction button for 1 second, and
release.
PAIRING
For your convenience, the Blue Parrott B100 base and headset have been paired in advance at the factory. However, if you have
since paired the headset or the base with an alternate Bluetooth product, you will need to pair the Blue Parrott B100 base and
headset together again.
See page 5 and 6 for location of button controls.
17
Blue Parrott B100 Wireless Headset Blue Parrott B100 Wireless Headset
10
STEP 3: Plug in the AC Adapter
Plug the AC adapter into the port on the bottom of the
Blue Parrott B100 base. Be sure to position the plug horizontally
as shown. Plug the AC adapter into the wall electrical outlet.
• Thread all cords through the cord slot with the AC cord running
between the other two cords (if applicable).
• For proper stability, be sure all cords exit through the curved opening on the base.
• You may bundle any loose or extra cord length together with the cord wraps.
• A dim green light will appear on the face of the base unit indicating that the base is
receiving power.
Note: More information on audio and visual indicators is available on page 20.
CHARGING THE HEADSET
Before first time operation, place the headset securely in the base and allow the unit
to charge undisturbed for 12 full hours. When fully charged, the headset indicator
light will turn green. A full charge will provide up to 6 hours of talk time before
needing to be recharged.
After use, the headset indicator light will turn red when it is set back in the base. Red
indicates normal charging/operating mode. It is not necessary to wait for a green
light to use the headset.