10
8.4 Use of drainage tube (cooled versions)
• NOTE: Use the drainage tube only when strict-
ly necessary.
Cooled cameras sometimes create condensation in-
side the camera body during normal use.
This condensation may interfere with the correct cre-
ation of the image on the sensor.
To remove any condensation, act as follows.
1. Disconnect all cables from the camera (power
supply and USB).
2.
Using a flat screwdriver, unscrew the screw
①
on
the left side of the camera. (Fig. 16)
3. Immediately screw the drainage tube
②
into the
empty hole. (Fig. 17)
• If the camera is connected to a USB cable or
power supply during this operation, there is
a risk that the electrostatic charge will attract
dirt and dust that will settle on the sensor.
• Periodically empty the drainage tube repeating in
reverse order the operations described above.
F
Fig. 16
ig. 16
①
F
Fig. 17
ig. 17
②
9. Use of camera
The camera is driven by the software PROVIEW.
You have to run the
setup.exe
file for the software installation.
At the end of the installation it is possible to start the software.
• NOTE: no driver installation is required for the cameras. The software setup procedure automatically
installs all the needed drivers for the correct operation of the camera
.
The software’s User Manual is available in PDF format within the application itself and can be opened using the
“F1” function key.
You must have Acrobat Reader installed to view the manual.
The manual contains all the operating instructions for using the camera and for the various functions of the soft-
ware.
