VWR 5700 Series, Operating And Maintenance Manual

Page: 15 / 90

Insert the power cord into the power inlet module. Place the retaining
bracket (P/N 195763) over the connector. Tighten retaining screws to
secure.
Note See the serial tag on the side of the unit for electrical specifications or
refer to the electrical schematics in this manual.
s
The freezer should be operated on a dedicated grounded service. Check the
voltage rating on the serial tag of the unit and compare it with the outlet
voltage. Then, with the power switch turned off, plug the line cord into
the wall outlet.
First, turn on the freezer power switch. Then open the lower front door by
grasping the bottom left corner. Locate the battery switch (Figures 1-3 and
1-4.) and turn it to Standby mode ( ). During initial freezer start-up, the
system battery may require charging and the Low Battery message may
appear in the message center.
Note Ensure the battery switch is turned to Standby mode ( ). The
rechargeable batteries require 36 hours to charge at initial start-up. A “Low
Battery” alarm may occur until the batteries are fully charged. Should a
power failure occur during the initial start-up period, the electronics will
have limited operation.
s
1-8 ULT Freezer VWR International
Section 1
Installation and Start-up
Attach Power Cord
Figure 1-11. Power Cord Retaining Bracket
Connect Unit to Electrical
Power