8
1. Set four posts (A) above four holes at the corners of the bottom platform.
2. Put the washer (B) on each screw (C) and then screw it into each post from the bottom side of the
platform.
3. Fit upper platform (D) on the top of four posts, so that the threads of the posts are protruding through
four corner holes.
4. Screw four nuts (E) on the threads of four posts, to fix the upper platform.
Replacing the fuses
Cleaning
and
maintenance
Prior to any cleaning or maintenance of the device, unplug the power cord from the wall
socket.
The housing of the rocker can be cleaned with a soft, damp cloth or special cleaners for plastic surfaces
(e.g. for car interior - armature). Do not immerse the device or spill liquids on the device.
NOTE: Do not use any aggressive or abrasive cleaners (acetone, nitro, polish etc.), because the
surface can get permanently damaged.
- No routine maintenance or lubrication is required.
- It is recommended that the rocker is kept clean to ensure long trouble-free operation.
Troubleshooting
Review the information in the table below to troubleshoot operating problems.
In case of malfunction, unplug the device from mains power supply and call authorized service
Problem Explanation
/
Solution
POWER switch doesn't illuminate when
turned ON.
Check the connection to mains power supply.
Check fuses.
Call authorized service.
Rocker doesn't start when you press
START/STOP key.
Check the connection to mains power supply.
Check fuses.
Call authorized service.
HOLD yellow signal light and RUN green
signal light are blinking.
Motor overload - reduce the load on the platform.
Call authorized service.
Fuse
compartment
Mains
socket
The following fuses are required for VWR Rocking Platform:
2 x 1 AT (115V and 230V)
Unplug the mains plug from the mains socket
By pressing the locking devices on two sides of the fuse
compartment, fuse holder is released and you can pull it out.
Replace the fuses.
Insert fuse holder and push it, until it locks.