47
7
Updating pipette settings
Here you can set the following configurations on the connected VWR Electronic pipette:
• Set the
Beep
to
On
or
Off
(switches the tone of the pipette to
On
or
Off
).
Beep On
and
Off
only
affects the built-in pipette protocols, as well as
Aspirate
,
Dispense
,
Mix
,
Purge
tasks (but NOT beep
task!).
• Set the
Lock pipette On
or
Off
(Lock pipette
On
disables access to Configuration, Speed and
Mode on VWR Electronic pipette)
• Set
Maximal volume limit:
this sets the maximal allowed volume on the particular pipette; it cannot
be higher than pipette’s specified maximal volume. Simply enter the volume (in μL) in the field.
• Update Firmware.
To modify these configurations, follow these steps:
1. Click
Update pipette settings
in the main menu.
2. If a pipette is already correctly connected, proceed to step 4.
3. Connect pipette to the PC via USB cable and click
Next
. Should the pipette not be recognized
immediately, disconnect the USB cable, reconnect it and click
Try again
button.
4. Check the checkbox for the configuration that you would like to change and then modify it (e.g.
change
Beep
from
On
to
Off
; or modify the
Maximal volume limit
);
Unchecked configurations will not be updated.
Summary of Contents for VWR 10
Page 31: ...31 19 REPLACEMENT PARTS COMING SOON...
Page 32: ...32 APPENDIX 1 EXAMPLE OF A PERFORMANCE CHECK example with VWR10 at 1 l...
Page 33: ...33 APPENDIX 2 Z FACTOR...
Page 52: ...52...
