DETAIL A
UPPER RIGHT CORNER
OF SCREEN
DETAIL B
BOTTOM RIGHT CORNER OF SCREEN
VUTEC CORPORATION
DRAWN BY
REVISED
DESCRIPTION
DRAWING NO.
SCALE:
REV
11711 W. SAMPLE RD. CORAL SPRINGS, FL 33065
THE INFORMATION
CONTAINED IN THIS
DRAWING IS THE SOLE
PROPERTY OF VUTEC
CORPORATION AND
REPRODUCTION IN PART
OR AS A WHOLE WITHOUT
THE WRITTEN
PERMISSION OF VUTEC
CORPORATION IS
PROHIBITED
ASSEMBLY INSTRUCTIONS:
1.
STARTING FROM THE TOP RIGHT CORNER, PULL THE
BUNGEE CORD BETWEEN THE GROMMETS UNTIL
MILDLY TENSIONED (ABOUT 7-12 POUNDS OF FORCE).
2.
WORK FROM RIGHT TO LEFT PULLING THE SLACK AND
TENSIONING.
3.
WHEN YOU GET TO THE TOP LEFT CORNER, PULL THE
SLACK THRU THE LAST GROMMET AND RE-WRAP THE
LACING POST ON THE CORNER BRACKET.
4.
REMOVE THE END WITH THE LOOP FROM THE LACING
POST AND PULL UNTIL IT HAS THE APPROXIMATELY
THE SAME TENSION AS BETWEEN THE GROMMETS.
5.
ATTACH THE LOOPED END TO A LACING POST. IF THE
LOOP STRETCHES MORE THAN 3-4 POSTS IN FROM THE
END, REMOVE THE KNOT AND RE-TIE IT FURTHER
DOWN.
6.
REPEAT STEPS 1-5 FOR THE BOTTOM, STARTING FROM
THE LOWER RIGHT CORNER AND WORKING FROM
RIGHT TO LEFT.
7.
ADJUST THE SCREEN UNTIL IT IS CENTERED
VERTICALLY ON THE FRAME.
8.
REPEAT STEPS 1-6 FOR THE RIGHT AND LEFT SIDES
RESPECTIVELY. THEN ADJUST THE SCREEN UNTIL IT IS
CENTERED HORIZONTALLY AND VERTICALLY.
9.
REPEAT STEPS 1-8, INCREASING TENSION UNTIL THE
SCREEN IS FREE OF WRINKLES AND SOUNDS LIKE A
DRUM WHEN TAPPED. THIS SHOULD NOT REQUIRE
MORE THAN 15-25 POUNDS OF TENSION AND MAY
REQUIRE LESS.
10.
AFTER THE SCREEN IS TENSIONED, EXCESS BUNGEE
CORD MAY BE CUT OFF. LEAVE 1-2 INCHES OF CORD
PAST THE KNOT FOR FUTURE ADJUSTMENTS.
ASSEMBLY STEP 7: TENSION THE SCREEN
START HERE (STEP 1) AND
WORK FROM RIGHT TO LEFT.
DO NOT START TENSIONING THE
SIDES UNTIL BOTH THE TOP AND
BOTTOM OF THE SCREEN ARE TENSIONED.
RE-TIE THE LOOPS AS REQUIRED AFTER TENSIONING
SO THAT THEY ATTACH TO A LACING POST WITHIN 18 INCHES
OF THE CORNER. EXCESS MAY BE CUT OFF AFTER TENSIONING,
LEAVE 1-2 INCHES OF EXCESS FOR FUTURE ADJUSTMENT.
ASSEMBLY INSTRUCTIONS
SILVERSTAR PANOFLEXX
PG - 10
SILVERSTAR\FLEX\
ASSEMBLYINSTRUCTIONS
NONE
--
D.TALLMAN
04/05/2019
