1.
2.
3.
Remove side panel (left or right):
A.
Loosen several screws securing brace [1]
Fig. 4 to broiler frame near the side panel to
remove. The upper front right of the broiler
is shown in Fig. 4.
Fig. 4
B.
At rear of broiler, loosen screws securing
the flue back panel [1] Fig. 5 to broiler frame
then lift panel off broiler.
NOTE:
The mounting holes in the flue back panel Fig.
5 are keyed to allow for easy panel removal without
having to remove all the screws that are also securing
the back panel Fig. 6 to broiler frame.
Fig. 5
C.
For the side panel being removed, remove
screws at the rear that are securing the back
panel [1] Fig. 6 and side panel to broiler
frame. Arrows shown in Fig. 6 are pointing
to the rear screw locations for right side
panel removal.
Fig. 6
D.
Remove side panel from broiler.
4.
Disconnect compression nut [1] Fig. 7 above the
control valve for the burner gas supply.
5.
Disconnect flexible tubing compression nut [2]
Fig. 7 from the pilot valve adjustment fitting.
6.
Separate union fitting [3] Fig. 7 at the bottom of
control valve to remove the valve.
Fig. 7
7.
Note locations then remove pipe fittings from
control valve.
Clean pipe threads and apply thread
sealant that is suitable for use with propane gases.
8.
Install pipe fittings on replacement valve.
V-SERIES HEAVY DUTY BROILERS, DOUBLE DECK AND RANGE MATCH MODELS - REMOVAL AND
REPLACEMENT OF PARTS
F45548 (0715)
Page 6 of 16
