Vulcan-Hart ML-138037, Installation & Operation Manual

Page: 7 / 28

VCW & VCD SERIES CHIP WARMER F-38053 (08-14)
6
OPERATION
OPERATION INSTRUCTIONS (Models VCD22 & VCD44)
The Warmer and its
parts are hot. Be very careful when
operating, cleaning, or servicing the
warmer.
1.
Switch Power Switch to ON
position. Verify that switch
illuminates. (Fig.5)
(Fig. 5 )
2. The internal thermostat is
factory preset to 180 ⁰ F. The
blower fan circulates heated air
through the perforated removable
chip tray located at the bottom of
the
interior of the cabinet
(under the chips.)
3. Open Top Door.
4. Pour chips into Baffle.
Do not overfill. The Top Door must
be able to fully close.
VCD22 holds approx. 22 gallons and
VCD44 holds approx. 44 gallons of
chips.
5. Close Top Door.
6. After approx. 30 to 40 minutes,
open Front Door to access
warmed chips.
7. Use the Chip Scoop to remove
desired amount of chips.
8. Close Front Door.
CLEANING INSTRUCTIONS (Models VCD22 & VCD44)
The Warmer and its parts are hot. Be very careful when operating,
cleaning, or servicing the warmer.
Always unplug electrical power supply before cleaning.
The inside of the Chip Warmer must be cleaned each day.
At the end of the day, switch Power
Switch to OFF position.
ALLOW UNIT TO COOL DOWN
1. Remove Access Panel by
unlocking
clips.
2. Place Access Panel away from
Chip Warmer.
3. Remove Top Door.
4. Remove all internal Baffles
through back opening.
5. Using a soft, clean cloth, clean
Top Door and Baffles with a
solution of mild detergent and
warm water. Rinse with a soft
cloth and warm water. Wipe dry
with a soft dry cloth.
Never spray the unit with a hose.
6. Using a soft, clean cloth, clean
the inside of the unit with a
solution of mild detergent and
warm water. Rinse with a soft
cloth and warm water. Wipe dry
with a soft dry cloth.
7. Replace Top Door and all internal
Baffles.
8.
Reattach Access Panel.