Vulcan-Hart ML-138037, Installation & Operation Manual

Page: 12 / 28

VCW & VCD SERIES CHIP WARMER F-38053 (08-14)
11
TROUBLESHOOTING
SYMPTOM POSSIBLE CAUSE REMEDY
Chip Warmer not
operating
Chip Warmer not
plugged into power
source. Plug chip warmer into correct
power source as indicated on
serial data plate.
Lighted power switch not
in ON position.
VCW26
& VCW46 Thermostat
knob not turned to
desired temperature
.
Press power switch to ON
position.
Check Thermostat knob
located in back of unit.
No power.
Contact Authorized Service
Provider.
Check GFCI switch on outlet.
GFCI or Ground
Fault Circuit
Indicator tripped.
Moisture problem. Dry moisture problem.
Damaged: element, wire,
power cord, etc. Contact Authorized Service
Provider.
Chip Warmer is
connected to
power source,
power is on, but
not heating.
Damaged: element, wire,
power cord, motor, etc. Contact Authorized Service
Provider.
Lighted power
switch is
illuminated, but
circulating fan is
not operating
Damaged fan, etc.
Contact Authorized Service
Provider
SERVICE & PARTS INFORMATION
To obtain Service and Parts information concerning this model, contact the Vulcan
Service Department at the address listed on the front cover of this manual or refer to
our website:
www.vulcanequipment.com for a complete listing of Authorized Service
and Parts depots.
Customer Service 1-800-814-2028
Technical Service 1-800-814-2028
Service Parts 1-800-814-2028
When calling for service, have the model number and serial number available.