Fig. 26
NOTE:
The door assembly is heavy and will drop
down once the last screw is removed. If removing door
assembly with-out assistance, use caution.
5.
Lift up on the door assembly and swing the right
side out then move the assembly to the left to
clear the slots in the upper door sill.
6.
Lay the door assembly on a flat cushioned
surface for disassembly.
7.
Reverse procedure to install door assembly and
check for proper adjustment as outlined under
DOOR ADJUSTMENT, DOOR CHAIN
ADJUSTMENT (SIMULTANEOUS DOORS) and
DOOR SWITCH ADJUSTMENT in SERVICE
PROCEDURES AND ADJUSTMENTS.
Disassembly
1.
Remove the door assembly as outlined in OVEN
DOORS (SIMULTANEOUS) under ASSEMBLY
REMOVAL.
2.
Remove the door chain by loosening one of the
turnbuckles.
3.
Loosen the set screw on the sprocket of door
being replaced.
4.
Drive out the spirol pin from the sprocket of door
being replaced.
5.
Remove the door from lower sill bearings and
sprocket.
Fig. 27
A.
Door assembly parts are now accessible for
inspection and/or replacement if necessary.
6.
Reverse procedure to re-assemble the door
assembly parts and check for proper adjustment
as outlined under DOOR CHAIN ADJUSTMENT
(SIMULTANEOUS DOORS) in SERVICE
PROCEDURES AND ADJUSTMENTS.
ROLLER LATCH ASSEMBLY
(INDEPENDENT DOORS)
NOTE:
For units with serial number starting with 48
made after 8/12/07 and serial number starting with 54
made after 8/26/07.
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
There may be multiple circuits. Be sure
all circuits are disconnected.
1.
Remove the screws that attach roller latch
assembly to door.
Fig. 28
VC4E & VC6E Series Full Size Electric Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
F25105 Rev. B (0217)
Page 16 of 64
