– 6 –
MEW14 WARMER REPLACEMENT PARTS
MEW14 MEDIUM DUTY ELECTRIC
COUNTER FOOD WARMER
SERVICE
WARNING:
THE FOOD WARMER AND ITS PARTS ARE HOT. USE CARE WHEN
OPERATING, CLEANING OR SERVICING THE FOOD WARMER.
WARNING:
DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT
BEFORE PERFORMING ANY SERVICE.
REPLACING PILOT "ON" LIGHT OR INFINITE (CONTROL) SWITCH
1. Remove control knob by grasping outer edge and pulling straight out, without twisting or
turning.
2. Remove two screws at top of front panel. Pull edge to open.
3. Disconnect leads to pilot or infinite switch and remove the damaged component. Mark
disconnected leads to identify them.
4. Mount the new infinite switch with fasteners provided. The new pilot light is snapped into
place from the front of the panel.
5. Connect leads to corresponding terminals on new component. Check completed circuit
against circuit diagram inside the front control panel.
7. Reverse steps 1 and 2 to close front panel.
REPLACING HEATING ELEMENT
1. Remove pan well hold-down nut located at center of bottom panel and accessible from
underneath the food warmer.
2. Carefully lift out pan well, and disconnect terminal leads to heating element.
3. Remove the heating element cover (secured by five nuts) and insulation covering the
heating element.
4. Remove heating element hold-down clamp, and remove damaged element.
5. Reverse Steps 1-4 to reassemble.
