Fig. 10
KETTLE ASSEMBLY
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
Removal
1.
Place kettle in full upright position.
2.
Support kettle using 2x4 blocks of wood.
Fig. 11
3.
4.
Disconnect thermocouple lead wires from
temperature control and the 4 pin wiring harness
connector.
5.
Note lead wire locations and disconnect from
load side of contactors.
6.
Remove wire tie securing lead wire bundle to
control box.
7.
Remove three set screws on pivot stop collar.
Access third screw thru the slot in top of control
box.
Fig. 12
8.
Remove outer bearing from support shaft.
Fig. 13
9.
On K20ETT only.
A.
Remove two bolts securing kettle tilt stop to
base.
Fig. 14
Electric Countertop Tilting Kettles, K6ETT, K12ETT, K20ETT - REMOVAL AND REPLACEMENT OF PARTS
Page 9 of 28
F35496 Rev. A (1117)
