Contact us for assistance: (866) 985-7877 | www.wtliving.com
10
OPERATING INSTRUCTIONS
CAUTION
Do not attempt to operate until you
have read and understand all General
Safety Information in this manual and
all assembly is complete and leak
test has been performed.
BEFORE TURNING GAS SUPPLY ON:
1. Your fire pit was designed and approved
for outdoor use only. Do NOT use it
inside a building, garage, or any other
enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and
other flammable vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections
are tight and there are no leaks.
4. Be sure the cylinder is clear of debris. Be sure any component removed during
assembly or servicing is replaced and fastened prior to starting.
BEFORE LIGHTING:
1. Fire pit should be thoroughly inspected before each use, and by a qualified
service person at least annually. If relighting a hot fire pit, always wait at least
5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear.
Suspected areas should be leak tested. If the hose leaks, it must be replaced
prior to operation. Only use the replacement hose assembly specified by
manufacturer.
WARNING
Very hot while in operation!
Never lean over the fire pit while in use.
Do not touch Table Top or Burner
Assembly while the fire pit is in operation.
Wait until the fire pit has cooled down
after use before placing Lid on Table Top
or touching any surfaces. Failure to comply
with these instructions may result in
serious bodily injury.
DANGER!
FOR OUTDOOR USE ONLY
CARBON MONOXIDE HAZARD
Never use this inside a house, or other
unventilated or enclosed areas. This fire
pit consumes air (oxygen). Do not use in
unventilated or enclosed areas to avoid
endangering your life.
WHEN FIRE PIT IS ON:
Burner will display tongues of blue and
yellow flame. These flames should
not be yellow or produce thick black
smoke, indicating an obstruction of
airflow through the burners. The flame
should be blue with straight yellow
tops. If excessive yellow flame is
detected, turn off fire pit and consult
the “Troubleshooting” page.
LIGHTING:
1. Turn the control knob to “OFF” position. (Figure A)
2. Fully open LP cylinder valve.
Note: For initial start or after any cylinder change, hold Control Knob IN for 2 minutes to purge
air from gas lines before proceeding.
3. Push in gas control knob and turn counterclockwise to “IGNITE” (Figure B) to light the fire pit. If needed, keep depressing and
turning control knob counterclockwise until the fire pit lights ( you should hear a clicking sound).
4. After fire pit lights, release control knob. Push in and turn the control knob counterclockwise to the “HIGH” Position then
release control knob If you want a lower temperature push in the control knob and turn counterclockwise to the “LOW”
Position (Figure C).
NOTE: If burner fails to remain lit, all valves should be close and a waiting period of at least 5 minutes should pass before
attempting to light.
Figure A
Figure B
Figure C
