COMMISSIONING
28
Notes:
If the burners extinguish and error code 11 or 12 starts to flash on the LED display:
release the MIN and adjuster buttons
close the hot tap
clear the error code (refer to
“Clearing Error Code”
on page 28)
recommence the procedure from Step 8.
If the adjuster button is released before Step 13, clear any error code (if displayed) and recommence the
procedure from Step 8.
Maximum test point gas pressure
Refer to the rating label on the water heater for the maximum test point gas pressure.
Follow Steps 8 to 14 of the
“Minimum test point gas pressure”
procedure on page 27, but open the hot tap
fully and use the MAX button instead of the MIN button. It may be necessary to open two or three hot taps
fully, depending upon the model of water heater and the incoming cold water temperature.
Note:
In Step 9
, “3H” (27 models) will be shown on the LED display.
After setting the minimum and maximum test point gas pressures:
Close the hot tap.
Remove the manometer and refit and tighten the test point screw and washer.
Open a hot tap again so the burners ignite.
Test for gas leaks.
Close the hot tap.
Switch off the electrical supply at the power outlet to the water heater
Refit the front panel and screws to the water heater.
Clearing Error Code
If an error code does appear on the LED display during the commissioning process, it will be necessary to
clear the error in order to complete the installation. To clear an error code:
switch off the electrical supply at the power outlet to the water heater
check the gas isolation valve at the gas inlet to the water heater is fully open
wait five (5) minutes
switch on the electrical supply at the power outlet to the water heater
PRESET OUTLET TEMPERATURE SETTING
The factory preset outlet temperature setting of the in-series gas booster is 60°C. The preset outlet
temperature setting can be adjusted (refer to
“To Check or Adjust the Preset Outlet Temperature Setting”
on
page 29).
Note:
AS 3498 requires that a water heater provides the means to inhibit the growth of Legionella bacteria in
potable water. When this water heater is used as an in-series booster for a solar water heater it can satisfy
this AS 3498 requirement provided it is energised, the booster preset outlet temperature setting is 70°C or
higher, and that a remote temperature controller is not used.
Note:
Consideration must be given to the delivery temperature to any ablution and public areas such as a
bathroom, ensuite or public amenities. Refer to
“Hot Water Delivery”
on page 17 and to the schematics of
Two Temperature Zones Using A Temperature Limiting Device
on page 18.
LED DISPLAY - TEST POINT GAS PRESSURE
CONTINUOUS FLOW WATER HEATER
86,87 SERIES, O22,024,027 MODELS
