VUE Audiotechnik VUEDrive V242, User Manual

Page: 6 / 10

R E I M A G I N E L O U D S P E A K E R S
WWW.VUEAUDIO.COM
1. Front panel network port jack.
2. Power LED indicator
3. Protection, Temperature for A and B amplifiers,
4. Sleep indicator for when the amplifiers is in power
down sleep mode.
5. Wink indicator for identifying the amplifier over the
network.
6. Input channel A and B meters with input Clip, input
Limiter engaged indicator, -6dB down from full input,
and Signal present.
7. Input channels A and B audio mute indicator.
V6-d REAR PANEL FEATURES
1. AC Power switch
2. Locking PowerCon connector (100 - 240VAC, 50-60 Hz)
3. Cooling fan (rear exhausting, air is pulled in the front of
the amp) do not to block the fan opening.
4. Speaker output A and B - two NL8 Speakon connectors
5. Analog input A and hard wired loop through XLR jacks.
6. Analog input B and hard wired loop through XLR jacks.
7. AES / EBU digital input and buffered loop through XLR
jacks.
V6-d FRONT PANEL FEATURES
8. Output channel A amp 1 and amp 2 meters with input
Clip, output Limiter engaged indicator, -6dB down from
full output, and Signal present.
9. Output channel A amp 1 and amp 2 Mute switches and
indicators
10. Output channel B amp 1 and amp 2 meters with input
Clip, output Limiter engaged indicator, -6dB down from
full output, and Signal present.
11. Output channel B amp 1 and amp 2 Mute switches and
indicators
12. Front cooling vent - Do not block vent openings and
clean vent filter when visibly dirty.
8. Two Ethernet port jacks for control with SystemVue
network software and audio input with Dante network
audio. Either port can be used. These jacks are
individual ports on an internal Ethernet switch, so they
can be linked to the next VDrive amplifier in a rack.
When using an external Ethernet switch one
jack should be connected to the network
switch. Connecting both ports to the same
network will cause contintion on the network.