Battery charging
The unit’s battery must be recharged before use.
The accessory micro-USB cable must be used for recharging the unit’s battery.
Connect the appropriate connector on the accessory micro-USB cable to the micro-USB port on the headphones, and the
USB plug on the other end to a USB port on a computer.
When recharging begins, the LED indicator on the headphones will light red.
Full recharging requires about three hours; when recharging is completed, the LED indicator will turn off.
When the battery’s charge is approaching depletion, a beep sound will be heard in the headphones at one-minute
intervals.
Note
Battery recharging time and usable battery time may vary depending on ambient temperature and frequency of use.
Do not place metal ojects near the headphones’ charging contacts, since dangerous electrical shorts or abnormal heating
may result.
Please don’t attempt to change the rechargeable lithium battery that should last the lifetime of the device.
Please don’t dispose used batteries/electronics with ordinary solid waste, since they contain toxic substances.
Please turn off your headset after your usage to get a longer battery life.
Pair headset with Bluetooth devices
1.
With the headphone power OFF, hold MFB button depressed for three seconds or more to power on and enter the
pairing mode. The pairing mode is confirmed by the LED indicator’s flashing blue and red.
2.
When in the paring mode, if pairing is not completed within about five minutes, the power will automatically turn off.
3.
Turn on the power to the bluetooth device you wish to pair with, and begin pairing; search for this unit from the paired
bluetooth device.
Set the bluetooth device within one meter to the wireless headphones.
These wireless headphones will appear in the bluetooth device’s display as “VT-H78N”.
4.
Confirm that pairing has been successfully completed with the bluetooth device.
Look at the display for the bluetooth-enabled device and select “VT-H78N”.
Pairing is confirmed when the LED indicator flashes blue at the intervals of three seconds.
The PIN code for these wireless headphones has been factory set at “0000”. Input this code if requested by the
bluetooth device.
Notes:
1. When the headphone already paired with a device, it will alternately connect when both devices powered on and
stay within 1m. If you want to pair with another device, please disconnect the previous device first.
2. If the pairing is not successful, please switch off headset firstly and then re- pair again.
Noise Canceling Function
When you slide the NC button to the “On” side, the indicator will turn on, then you can enjoy the headphone in Noise
cancellation mode. When you don’t need the Noise cancellation function, please slide the NC button to the OFF side.