7
Figure 6 Stepper Motor 4Nm and 8Nm assembly schematic
3.2 Connection and wiring
To perform the correct setup, please refer to the following diagrams representing possible ways of motor
connection. Installation and connection can be done by qualified personnel only. Failure in performing in
any of this operations may result in risk of fatal injury, electric shock, incorrect mounting or product
damage.
WARNING
:
Do not open or disassemble the motor nor controller while power supply is connected to the device. It
may result in fatal injury caused by electric shock. If it is necessary to open the motor, wait at least 5 minutes after
disconnecting from the power supply.
Notes on proper installation:
Use fuses at power line.
Check the wires condition before operating. Make sure that there are no short circuits.
Use cables fulfilling the voltage, current, load and insulation installation requirements.
Use only high quality hard wire or fiber copper wire with ferrule.
Use shield cable.
Make sure that motor label plate specification matches the operating supply voltage. Use cables that are
adapted to work with the desired current.
Stepper motors used in series of VTS Heat Exchangers (Figure 7) are connected and powered via controller responsible
for basic operational parameters. Motor itself is equipped with male type terminal which characteristic are described
below in the Figure 8.
