VTech Kidizoom camera Connect, Parents' Manual, Page: 9 / 32

9 9
9
GETTING STARTED
When you use the KidiZoom
®
Studio
camera for the first time, switch the
Master Power Switch
to the
position.
When the
Master Power Switch is in the
position, it is not possible to charge
the camera or play any activities, and the
system clock will be reset.
BATTERY CHARGING
Note:
Adult operation required.
• Make sure the camera is not in use and the Master Power Switch
is in the position. Pull up the rubber cover over the
Micro-USB
Port
on the side of camera.
•
Insert the
Micro-USB Cable
(small end) into the
Micro-USB Port
on the camera.
•
Insert the large end of the
Micro-USB Cable
into a USB port on a
computer.
•
When the battery is charging, a red LED will light up
and you will see the battery charging icon.
•
When the battery is fully charged, the LED will turn
green, then the screen will turn off. You may then
disconnect the camera from the power source.
Charging Guidelines
Only charge this device using the included Micro-USB cable connected
to a computer. Do not charge using a third party adaptor. Before use,
inspect the cable to confirm that it is in good condition and that there
are no breaks or exposed wires. Ensure there are no particles or liquid
(water, juice, etc.) in either of the connectors before plugging in either
end of the cable. The device should be completely dry with no debris
in the cable connectors when charging. Plug in the cable securely, in
the correct orientation. If the device is on when plugged in, a dialog
box may open on your computer to allow you to access the device’s
drive. Never leave the device unattended while charging. Do not
5318 UK IM.indd 9 04/28/2020 17:13:22