37
Appendix
Replace a handset
If you want to replace a handset or reassign the designated handset number
of a registered handset, you must de-register all the handsets and then
individually register each handset.
To make de-registration easier, read all of the instructions on this page before
you begin. To de-register all handsets:
Press and hold
/FIND HANDSET
on the telephone base for about 10
seconds (until the
IN USE
light on the telephone base turns on and starts
to flash), then release
/FIND HANDSET
.
Press
/FIND HANDSET
again. You must press
/FIND HANDSET
while
the
IN USE
light is still flashing. The
IN USE
light flashes for approximately
seven seconds.
All system handsets show
CONNECTING...
The de-registration process
takes about 10 seconds to complete. All handsets show
NOT REGISTERED
when the de-registration completes.
If de-registration fails, you might need to reset the telephone and try again.
To reset:
Pick up the registered handset and then press
.
Press
OFF/
CLEAR
and place the handset back in the telephone base.
-OR-
Unplug the power from the telephone base, then plug it back in.
1.
2.
3.
1.
2.
1.
You cannot de-register a handset if any system handset is in use.
