2
Connect base unit
Connect the base unit as shown below.
The ErisStation Conference Phone is not a network device and is not PoE (Power over
Ethernet) compatible. It does not require an ethernet network to work. Do not connect it to
your ethernet network or directly with any other network devices.
The supplied power adapter is designed for use with the ErisStation Conference Phone only.
It is not PoE compatible and is not designed to power any network devices. Do not connect
the supplied power adapter to any other network devices through the supplied DC power
cable or any other Cat5e ethernet cable.
When the base unit is powered up, the status indicators turn green for about two seconds.
If you subscribe to digital subscriber line (DSL) high-speed Internet service through your
telephone line, you must install a DSL filter between the telephone line cord and wall jack.
Contact your DSL service provider for more information about DSL filter.
The AC power cord is intended for a vertical or floor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a ceiling or cabinet outlet.
•
•
•
•
•
Plug one end of the DC power cable into the base unit, and plug the other end
into the
VCS704
jack of the power adapter. Route the cord through the slots.
Plug one end of the telephone line cord into the
TEL LINE
jack of the power
adapter, and plug the other end into a wall jack.
Plug the small end of the AC power cord into the power jack of the adapter, and
plug the large end into the wall outlet not controlled by a switch.
1.
2.
3.
Getting Started
Wall jack
1
TEL LINE
VCS704
2
3
Wall outlet
DC power cable
Telephone
line cord
AC power cord
Slots
E
