Appendix
70
California Energy Commission battery charging testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the box. These
instructions are intended for California Energy Commission (CEC) compliance testing only. When the
CEC battery charging testing mode is activated, all telephone functions, except battery charging, will
be disabled.
To activate the CEC battery charging testing mode:
Unplug the telephone base power adapter from the power outlet. Make sure all handsets are plugged
with charged batteries before proceeding.
While you press and hold
/FIND HANDSET
, plug the telephone base power adapter back to the
power outlet.
After about 10 seconds, when the
IN USE
light starts flashing, immediately press
/FIND HANDSET
again. You must press
/FIND HANDSET
while the
IN USE
light is still flashing. The
IN USE
light
flashes for about five seconds.
When the phone successfully enters the CEC battery charging testing mode, all handsets
alternately show
To register HS...
and
...see manual
.
When the phone fails to enter this mode, repeat Step 1 through Step 3 above.
To deactivate the CEC battery charging testing mode:
Unplug the telephone base power adapter from the power outlet, then plug it back in. Then, the
telephone base is powered up as normal.
Register your handsets back to the telephone base. Refer to
Add and register a handset
.
1.
2.
3.
•
•
1.
2.
