Installation
5
Installation
Installation option - converting from desktop to wall mount position
Unplug the Cat-5 network cable from the network wall jack.
Put the handset aside. On the telephone base, place a coin in the slit of the wall mount clip and rotate a half turn (180 degrees).
It locks into place with the protruding edge pointing towards the upper edge of the telephone base. This protruding edge holds
the corded handset when the phone is mounted on the wall.
Remove the mounting bracket from the upper grooves of the telephone base.
Rotate the mounting bracket. Insert the tabs of the mounting bracket into the lower grooves of the telephone base.
Mount the telephone base on the wall by aligning the eyelets with the mounting studs of the wall plate. Then slide it down on
both mounting studs until it locks into place.
Plug the Cat-5 network cable back to the network wall jack with Power over Ethernet (PoE). Then replace the handset on the
telephone base cradle.
1.
2.
3.
4.
5.
6.
Protruding
edge
Network wall jack with Power
over Ethernet (PoE)
Eyelets
