Setup
Registration And Operation Of The 2422 Accessory
Handset
Your GIGAPHONE system can operate up to 4 Handsets.
The accessory Handset consists of the following:
Getting Started
4
5
Follow the steps below:
1.
Remove the battery cover by pressing
on the indent and sliding downward.
2.
Place the new battery pack in the
handset with the metal contacts
aligned with the charge contacts in
the battery compartment.
3.
Replace the battery cover by sliding
it upwards.
4.
If the new battery pack is not already
charged, place the handset in the
base unit, or a remote charging
stand, and allow it to charge for 12
hours. After initial charge, a
maintenance charge of 8 hours
should be sufficient.
Installation of Battery Pack in Handset
The original Handset that is shipped with your GIGAPHONE system will be automatically
registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension
numbers in the following order: HANDSET 2, HANDSET 3, and finally HANDSET 4.
Whenever a Handset battery pack is installed, the Handset will automatically begin
SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER
BASE ID to register the new Handset.
Setup Of The 2422
Accessory Handset
1.
Plug the AC power adapter into an
electrical outlet.
2.
Remove the Handset battery cover
by pressing on the indent and sliding
downward.
3.
Place the new battery pack in the
Handset, with the metal contacts
aligned with the charge contacts in
the battery compartment.
4.
Replace the battery cover by sliding
it upward.
5.
Place the Handset in the Charge
Cradle, and allow it to charge for 12
hours. After the initial charge, a
maintenance charge of 8 hours
should be sufficient.
Handset
Battery Pack
Charger Unit
Belt Clip
1
3
2
1
5
3
