VTech Baby 550103, Instruction Manual

Page: 5 / 15

5
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned
OFF
.
2. Find the battery cover located on the back
of the unit, use a screwdriver to loosen the
screw and then open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 3 new AA batteries following the
diagram inside the battery box. (For
best performance, alkaline batteries or fully charged Ni-MH
rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach
of
children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.