Mainframe system installation position should be under the meter board or in the front seat shelter, make
sure that the mainframe is under the fixed position, then let the GSM anti-theft exit line according to the
wiring diagram, port description connect with the car ACC, direction lights, brake lights and also the
power supply; Don't connect in the middle part of wire just for the convenient purpose. If suffer the
condition restrict, forced to connect in the middle part of wire (if engine power cut off loop), should make
sure that the middle part of wire located with the isolation bind up, then put all the wiring harness pin and
also the GPS mainframe’s socket corresponding connected with each other, then according to the front
recommendation function to make the initial test, make sure there are no mistakes and pack the wire tidily,
then put it in the origin position.
**Distances should be reserve for GSM antenna and the GPS anti-theft mainframe; antenna
position should follow the car state when setting it.
z
Vibration Sensors Installation:
After finished the mainframe installation, vibration sensors should fix-up (close to body or to install meters
near the site to make sure that the vibration sensors is in the detect scope), then according to the size of
vehicle and the actual needs, do appropriate adjustments detection sensitivity.
Please note: the system placed the remote signal receiver in vibration detection boxes, and therefore,
attention is drawn to remote antenna installation can not bear tied together with other wire rod should be
left free to enhance remote distance;
z
Central control door locks installation
(below are the few types of installation)
1. The original car door locks no impetus to door locks, a suggestion is to install electric center control
lock, refer to Figure 2 wiring;
2. The original vehicle equipped with central control door locks, but only one driver seat’s switches to
bring along the other three door locks. Hence, it is can also to install one motor in the driver’s seat. refer
to Figure 4 wiring;
Original cars equipped with central control door locks, judgment is needed for the positive trigger or
negative trigger types. Please refer to Figure 2, 3 wiring.
z
System Problem & Solve Method
:
1
、
Firstly, please make sure that the system Sim-Card has been installed; Check the power supply
on/off.
2
、
Finished the Sim-Card installation and on the power supply, and hear “
notice
，
GSM net signal
faintness
”
，
please re-check does the Sim-Card is installed well and re-install the Sim-Card
once again
.
3
、
Finished the installation, you can’t call in the system phone, this is because the mainframe
12
