The concave and convex bayonet of the joint shall be matched correctly
Screw Nut: Just screw the nut when the cable connected
but not twist the cable or the connector
Rubber damping ring
Screw
Double-sided
foam tape
Double-sided
foam tape
- 6 -
The connection should follow
the same color and the correct
arrow direction.
The input voltage never exceeds 5V and
the current needs to be 2A or above for
the USB power source to make sure the
dash cam works properly.
1) Connect cam 1 & cam 2 to the main unit.
2) Find the USB test cable and connecting to the power bank or USB adaptor to do a quick
test before installation.
3) Prepare installation if everything looks good.
Quick Test
Camera Installation
+
-
Positive
Negative
Double-sided foam tape
double-sided foam tape
+
-
Power Module Installation
M
E
N
U
O
K
Connect red wire to the battery positive terminal, black wire to the negative terminal.
The smart power module works by detecting the voltage change or continuous vibration.
• Make sure the power module is installed in a place that can detect the bike vibration .
• The dash cam automatically powers on when the engine is started. It won't work if only the ignition
switch is turned on.
• The dash cam will continue to record for approximately 5 minutes after the motorcycle is turned off,
and then shut down.
