RADIANCE ROTATING HOT-AIR STYLER
10
OPERATING INSTRUCTIONS
Wash, condition & towel dry your hair.
Ensure your hair is slightly damp, combed through & tangle-free.
1. Make sure the switch is set to the off (‘0’) setting before plugging
into a 240V~ suitable power outlet.
2. Divide your hair into sections, between 2.5cm - 5cm wide & no
more than 1cm thick (if you have thick hair make the section around
5mm thick).
3. Attach the soft bristle brush & switch to the high heat/speed (II)
setting for initial drying.
4. Place the styler under the section of hair, close to the roots & brush
through the section to remove tangles (without brush rotating).
5. Switch to the low heat/speed (I) setting for further drying & styling
then move the brush through the hair section (hair is draped over
top of brush), towards the ends.
6. When you reach the end of the hair section, start to rotate the
brush away from your head by pressing & holding the appropriate
rotation direction (‘
’) setting.
NB:
As you do this, it is important to resist the rotation of the brush by
pulling the brush downwards. The brush should be rotating through
the section of your hair without the hair becoming wound round the
brush head (if you are holding the styler with the correct tension
against the hair).
7. To release the section of hair, press & hold the opposite rotation
button.
8. Repeat this through all sections.
9. To finish, switch to the cool (‘ ’) setting to set the style for longer
lasting results after drying.
NB:
The brush does not rotate on this setting.
Allow the styler to cool, before placing the protective brush cover
over the brush head to protect while stored away.
