VS Sassoon Unbound VSC510UA, Instruction Booklet

Page: 23 / 36

UNBOUND CORDLESS AUTO CURLER
23
TROUBLESHOOTING
HAIR TANGLING
MIX SETTING = ALTERNATE CURLS WARNING!
Possible Cause:
Finger has been removed from the button before
all required beeps. Hair has become tangled after repressing the
button.
Solution: MIX setting = Alternate curls. If you take your finger off the
button whilst hair is curling and then re press the button while
your hair is still in the curler, the curler will start spinning the other
way because it now thinks it is creating a new curl...
this will create
a tangle in your hair.
If you take your finger off the button accidentally during curling
remove the styler from hair immediately.
To correctly curl a hair section - press and continuously hold the
button to draw the hair section into the curl chamber, making sure
100% of the hair section enters the curl chamber at the same time.
DO NOT remove your finger from the button until you hear
the required succession of slow beeps corresponding to the timer
setting you’ve selected. When you hear the 2 rapid beeps, you
can then release your finger from the button.
Possible Cause:
The section of hair being inserted into the curl
chamber is too thick/big.
Solution:
BEFORE USE - Section hair and comb through until its
completely tangle-free. Clip away each section not being styled
with sectioning clips. Ensure there are no stray hairs within each of
the sections.
Take a section of hair 1.5cm to 2.5cm, depending on your hair length.
For longer hair, take smaller sections and start curling from the mid
lengths to ends of the hair section.
ALWAYS ensure that you place the entire smooth section of hair
into the curl chamber. ENSURE ALL OF THE HAIR SECTION SITS
INSIDE THE OPENING OF THE CURL CHAMBER - THERE SHOULD
BE NO STRAY HAIRS.