Vremi VRM050696N, Manual

Page: 18 / 24

Portable Air Conditioner | 18
WATER DRAINAGE METHOD
Operating Instructions
When there is excess water condensation inside the unit, the appliance stops running and shows “ ” (FULL TANK
as mentioned in SELF-DIAGNOSIS). This indicates that the water condensation needs to be drained using the
following procedures:
Manual Draining (fig.17)
Water may need to be drained in high humidity areas
1. Unplug the unit from power source.
2. Place a drain pan under the lower drain plug. See diagram.
3. Remove the lower drain plug.
4. Water will drain out and collect in the drain pan (may not be supplied).
5. After the water is drained, replace the lower drain plug firmly.
6. Turn on the unit.
18
Continuous Draining (fig.18)
While using the unit in dehumidifier mode, continuous drainage is recommended.
1. Unplug the unit from the power source.
2. Remove the drain plug. While doing this operation some residual water may spill
so please have a pan to collect the water.
3. Connect the drain hose (1/2” or 12.7mm, may not be supplied). See diagram.
4. The water can be continuously drained through the hose into a floor drain or
bucket.
5. Turn on the unit.
NOTE:
Make sure that the height of and section of the drain hose should not be higher than that of the drain outlet, or the
water tank may not be drained. (fig.19 and fig.20)
19 20
17