10- Tail wheel
1
2
3x15mm screw
...............4
...................1
2mm tail gear horn
Tail gear mount
................1
Four nuts are installed at factory.
3
4
5
NOTE: Insert the tail gear
pushrod into the tail gear
horn before insert the tail
gear horn on to the tail
gear mount (step 2)
!Securely glue together. If coming
off during flight, you lose control
of your air plane.
-Trial fit each part before gluing . Be certain that there are no gaps.
If the parts will join, but with a gaps, sand or trim the parts a little
at a time until the parts meet exactly with no gaps.
-When joining the stabilizer it is extremely important to use plenty of epoxy (30 minutes) or CA
glue (thin type).
-Carefully slide the stabilizer into the fin, ensuring that they are accurately aligned, using rubbing
alcohol and paper towel, clean off the excess epoxy.
A B
Cut away only the film
(top and bottom)
A = A’
B = B’
A
A’
11- Vertical / Horizontal Tail
Plastic control horn
....................3
2x25mm screw
...............6
C = C’
B
B’
C
C’
5/64(2x25mm)
screw
Hinge
Petroleum
jelly
STABILIZER
A B
Apply 5 min.
Epoxy both the
top and bottom.
3/8 in. (9.5mm)
Apply a thin layer of machine oil or petroleum jelly to only the pivot point of the hinges on
the elevator, then push the elevator and its hinges into the hinge slots in the trailing edge
of the horizontal stabilizer.
There should be a minimal hinge gap.
When satisfied with the and alignment, hinge the elevator to the horizontal stabilizer using
5 minute epoxy. Make sure to apply a thin layer of epoxy to the top and bottom of both hinges
and to inside the hinge slots. Repeat the previous procedures to hinge the second elevator to
the other side of the horizontal stabilizer.
A B
A B
5mn epoxy
5mn epoxy
30mn epoxy