7- Aileron servo
WING - BOTTOM VIEW
L/R
Assemble left and right wings
the same way
LEFT- WING
CENTER-WING
Dowel
Dowel
CA
8- Joining the wing
A B
Metal rod, D=5/64 in. (2mm) do not glue here
A
B
WING - TOP VIEW
!Securely glue together, If coming
off during flights, you lose control
of your airplane which leads to
accidents !
1- Trial fit the wing joiner, into one of the wing panels. It should insert smoothly up to the center line marked. Next,
slide the other wing half onto the dihedral brace until the wing panels meet. If the fit is overly tight, it may be
necessary to lightly sand the dihedral brace.
2- Check for the correct dihedral angle
3- Apply a generous amount of epoxy into the wing joiner cavity of one wing half. Next, Coat one half of the dihedral
brace with epoxy up to the center line. Install the epoxy-coated side of the dihedral brace into the wing joiner cavity
up to the center line.
4- Do the same way with the other wing half. Carefully slide the wing halves together, ensuring that they are accurately
aligned. Firmly press the two halves together, allowing the excess epoxy to run out. Clean off the excess epoxy.
5- Apply masking tape at the wing joint to hold the wing together securely while the epoxy cures.
Aileron servo
extension (N.I)
L/R
Assemble left and right wings
the same way
Flap servo
Flap push-rod
Retract servo
Aileron servo
Aileron push-rod
9- Linkages
WING - BOTTOM VIEW
Flap push-rod
IMPORTANT:
Please do not clean off the excess epoxy on the wing with strong solvent or pure alcohol, only use
kerosene to keep the colour of your model not fade.