2.5x10mm.....5
1.5mm
22- Cowling
(1~2mm)
Board or
transparent
plastic.
Adhesive
tape
Attach the board or transparent plastic on the side of
the fuselage with the adhesive tape as show.
Using a pencil or felt tipped pen trace around the engine
head where it meet the cowl. Cut the opening the board
or transparent plastic for the engine head as marked
before.
Remove the engine and insert the cowl on to the fuselage
so the distance from the fire wall to the front of the cowl is
4-23/32” to 4-55/64”(120 to 122mm).
Remove the cowl from the fuselage and carefully cut the
opening for the engine head as marked above. Do the
same way with the hole for needle-valve.
Again. Insert the cowl on to the fuselage and secure it in
place with five 2.5x10mm self tapping screws.
121mm
Ruler
1/16”
Board or
transparent
plastic.
Cut the
opening
CA
ABS tail wheel
cover
ABS cover
2mm self tapping
screw
23- Tail wheel cover
2x5mm screw
..........6
ABS tail wheel
cover
1.5mm
1/16”