A B
! Make sure to glue
securely, If not properly
glued, a failure in flight
may occur.
1-
Joining the wing
A B
20mm
15mm
Draw the center line
on the wing joiner
- Trial fit each part before gluing . Be certain that there are no gaps.
If the parts will join, but with a gaps, sand or trim the parts a little
at a time until the parts meet exactly with no gaps.
- Check for the correct dihedral angle
A B
Glue must go inside
Wing joiner
Glue
Wing half
Rubber band
(not include)
Paper clamp
(not include)
Nylon wing bolt
(included)
Hold the wing halves together with paper clamp
and rubber band
A B
Before gluing:
- Draw the center line on the wing joiner.
Note: The two wing halves roots must fit together perfectly.
IMPORTANT:
Please do not clean off the excess epoxy on the
wing with strong solvent or pure alcohol, only use kerosene to
keep the colour of your model not fade.
Cut through the balsa
wood and the covering
Thread
Thread
Adhesive tape
Pull the thread to out of the wing
through the square hole you make
above and secure it in place with
the adhesive tape.
WING HALF-TOP VIEW