CESSNA 208
11-Horizontal stabilizer
Push the horizontal stabilizer into the slot on the
fuselage as show. Check the alignment of the
horizontal stabilizer by measuring from a fixed
point along the center line of the fuselage to the
leading edge on each side of the horizontal stabilizer.
The distance must be equal on both sides .
If not, adjust the stabilizer until the measurements
are the same.
When you are satisfied with the alignment, use
a pencil to trace around the top and bottom of
the stabilizer where it meets the fuselage.
Cut away only
the covering
both side
Remove the horizontal stabilizer
from the fuselage. Using a straight edge
and a sharp hobby knife, carefully cut away
the covering
inside the lines
which were marked
above. Be cautious
not to cut into the wood
-this
will weaken the structure
.
Pull the left and right elevator out of the horizontal
stabilizer.
Using a sharp hobby knife, carefully cut away
the covering around of all slots for the horizontal
stabilizer and vertical fin installation.
Cut away only
the covering
Cut away only
the covering both sides.
A
A’
A=A’
Summary of Contents for CESSNA 208
