! Engine thrust on balk head
is already adjust at factory
SIDE-VIEW
122-124mm
FUSELAGE
Position the engine to the engine mounts so the distance from the prop hub
to the fire-wall is 122 - 124mm.
Mark the engine mounting plate where the four holes are to be drilled (2A)
Remove the engine and drill a 3mm holes through the beam at each
of the four marks made above (2B)
Reposition the engine on the engine mount
beams, aligning it with the holes. Secure the
engine to the engine mount using four
3x25mm screws (2C)
Note: Apply Silicon sealer to each of the
3x25mm screw and nut.
.......4
3x25mm screw
Washer
.......4
C=122-124mm
Marking sure that you drill the hole perpendicular to the beam of the
engine mount.
3mm
X
To muffler
Filler tube
To engine
3x35mm screw
Rubber stopper
Checking for leaks - block the vents
and blow into the feed - if in doubt
submersing the tank in a blow of
water will show up any problems.
Blow
Water
Carefully install the fuel tank
to ensure that they will not
shift during flight (2F).
2- ENGINE
2A
2B
2C
2D
2E
2F
C
