Note: Cut out the stickers and apply them in the proper area. Do not
peel the backing paper off all at once.
Peel off one corner of the backing and cut off with scissors.
Arrange sticker on model and when satisfied adhere the corner without
backing.
Carefully peel back the rest of the backing while at the same time
adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully puncture sticker
(center of bubble) but not model surface with
the tip of the knife or sharp pin and squeeze out the air.
At curves stretch sticker and apply a little heat so that no ceases occur.
Cut off the excess that is produced.
2mm
2.5x10mm screw
.........4
2mm
AICHI DECAL SHEET 40X36 VQ MODELS
21- COWLING
22- GUN & DECAL
